NEW YAMAHA IMPACT TRIM ROD REMOVAL WRENCH, - 1.5" USUALLY A 4 STROKE

Description

IMPORTANT
NEW IMPACT /
RATCHET
TRIM-WRENCH DISC...YOU RECEIVE ONE DISC AS SEEN IN PICTURE #2, OTHER PICTURES ARE FOR
ILLUSTRATION
ONLY.
PLEASE CHECK THESE MEASUREMENTS FOR A SURE FIT
.
THIS
3/8" DRIVE IMPACT TRIM WRENCH WILL FIT THE TRIM ROD CAP THAT HAS 5/32 DIAMETER HOLES WITH A CENTER TO CENTER DISTANCE OF ( 1 1/2" OR 1.5 ) USUALLY A 4 STROKE
NEW IMPACT WRENCH
THIS WRENCH WAS DESIGNED TO SOLVE THE PROBLEM OF REMOVING THE ALUMINUM CAP FROM THE YAMAHA TRIM ROD ASSEMBLY WITHOUT DESTROYING IT. THE CAP HAS FOUR HOLES AND IT MAKES MORE SENSE TO USE ALL FOUR HOLES WHEN REPLACEMENT IS NEEDED, RATHER THAN TWO LIKE MOST SPANNER WRENCHES.
TRIM WRENCH IS MADE OF STEEL WITH A BLACK OXIDE FINISH. THE PIN ASSEMBLY IS MADE UP OF A 5/16-24  HEAT TREATED ALLEN CAP SCREW AND HAS A 5/32 DOWEL PIN PRESSED INTO THE BODY.  THIS ASSEMBLY DESIGN ALLOWS YOU TO REPLACE A PIN IF DAMAGED BY UNSCREWING THE CAP-SCREW AND REPLACING IT WITH A NEW ONE THAT ARE AVAILABLE THROUGH OUR STORE... MOTO-STOP-SHOP AT .45 EA.
FOR SUZUKI & HONDA'S PLEASE CONTACT US
PLEASE EMAIL ANY QUESTIONS OR COMMENTS ABOUT THIS ITEM.
ALL OF OUR PRODUCTS ARE FULLY GUARANTEED AND MADE IN THE USA